Jump to content
  • Your friend, The Wind


    jhn.holgate

    With all the talk of buggys, landboards and kites, it's probably fair to say that without wind, you won't be going very far at all.  Wind can be fickle, hot dry and gusty and pretty much un-fly-able.  Wind can be cold, dense, smooth and beautifully predictable.  And anywhere in between.  If you've never thought about how the wind interacts with the land, picture this:

    You're standing on the bank of a fast moving stream.  In the center the stream is fast and smooth.  It slows down as it nears the bank due to friction with the land.  Any obstacles, rocks, trees etc disturb the flow of the water and the water will often be flowing in the reverse direction as it goes around and eddies back in behind the obstacle...

    Image result for river eddies

    If there's a lot of obstacles, it can be a quite a chaotic mess.  Now, pick the whole stream up and stand it on it's edge and you have a pretty fair picture of how the wind interacts with the land.  Buildings, trees, hills etc will all affect the flow of the wind the same as the water in the stream.  You need to get up and away from them to find the smoother air higher up.  But with power kites, we don't have the luxury of letting out 150 meters of line to get the kite above the disturbances so we have to examine our surroundings.  Buildings, trees and undulations will affect the wind a lot further than you think - you need to be as far downwind away from them as you can.  When I was in my early 20's I used to build and fly stunt kites but I didn't know much about how the wind was affected by it's surroundings.  If there was wind, great, I could fly in the local park....so I thought.  It cost me a few smashed stunt kites to slowly work out it was all the trees and buildings that were the problem.

    But it's not just getting away from obstacles that we need to think about as inland kiters - thermals can make a bit of a mess out of the wind too.  A thermal happens when the sun heats up a particular section of land - maybe it's on the side of a hill facing the sun, maybe it's a plowed paddock that's a little darker...or a car park, road, building etc.  As the land/carpark/building warms up, it, in turn heats the air above it.  At some point a warm 'bubble' of air gets heated enough to rise up from the ground - becoming a thermal.  Ever watched a lava lamp?

    Image result for lava lamp

    Thermals in action!   And when that bubble of warm air breaks free of the ground and rises - cooler surrounding air has to rush in and fill the void.  Thermals are great for glider pilots (or birds!) as you can gain height for free by flying round and round in them - some are large and some are narrow and some can be a bit violent.  For a land kiter, it all adds more variability into the wind.   You might think you're in a clear location and the wind is relatively smooth, but if there's thermals going off around you, you may suddenly find serious shifts in both wind speed and direction.   Sometimes your best chance of smooth wind is an overcast day where the sun is not creating yet more havoc.

    Sometimes thermal activity may be obvious by all the cumulus clouds building around you, but rising air doesn't always result in a cloud being formed...

    Image result for thermals cumulus

    So, don't choose a spot surrounded by trees to fly.  Or buildings.  Get into a clear an area as possible.  If it's a little elevated, better still.  Truganina is a good spot in Melbourne - it's elevated and mostly clear of trees.  While it still can be pretty turbulent and gusty, it's pretty good for an inland spot.  If the wind is coming off the bay, better still.

    Truganina IMK.jpg

    The best wind for kiters is the afternoon seabreeze.  The sun heats the land and towards the end of the day, the air over the land begins to rise and the cooler air over the sea rushes in - it can be quite sudden.  I've been at Kingston where I was barely flying in 6 knots and then within 5 minutes, the seabreeze of 20 knots came in.  The seabreeze can be really smooth with very little variation and flying in it is an absolute joy.  The kite stays nailed to the sky and you'll feel far more in control.  That's why we will travel long distances to get, not only the smoother wind coming in from the ocean (or bay), but also the large expanse of hard sand the low tide exposes.  

    Temperature of the air will affect your kiting too.  I've had good sessions with a 6m Ozone Access in 12 - 13 knots - a wind speed that would normally be a bit low for that kite, but it was a cold dense wind.  The same wind speed in Queensland (for example) would be a lot warmer and less dense and hence I'd probably need at least the next kite size up.

    If I'm contemplating a kiting session at home, I will give the trees a good look - if they're bent over in the wind, but otherwise not moving about much, that's great.  It means a consistent wind.  If they are waving wildly back an forth, not so good, that means lots of gusts and lulls.  And I hate it when you're flying a foil in gusty wind and there's a big lull, the kite promptly folds up in a ball and begins to fall out of the sky and back in to the middle of the window only to be hit by the next gust, then unfurl in the middle of the window and go POW!!  "I'm back now"! and tries it's best to rip me out of the buggy.  Sometimes the wind is so gusty and messed up, that it's just not worth the risk in flying.  And sometimes it's smooth and a joy.  Learning to pick the right conditions takes a bit of time and observation but will repay with you safer and more enjoyable flying conditions

     



      Report Article


    User Feedback


    There are no comments to display.



    Guest
    You are commenting as a guest. If you have an account, please sign in.
    Add a comment...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

    Loading...

×