I had a zipper on my 16m venom 2 give up on me last week. Bloody frustrating, as it was the inflate zipper and I was about to launch 🤬. The slide was so worn out that it won’t close the teeth anymore.
anyway, I have fitted new waterproof zips to an arc before, but they can be a bit expensive and hard to find. So I thought it was a good chance to test out a Velcro alternative.
its basically just a short sock and Velcro opening similar to the deflates in the flysurfer kites.
the Velcro valves work quite well. I inflated the kite and slowly opened the Velcro. No air was escaping until it opened far enough to for the end of the sock to open.
Sorry, no pictures before they got sewn in. But a few pointers I worked out for anyone wanting to do this mod.
-Make the sock width about 50mm more then the zipper opening in the kite.
- place sticky ripstop inside the kite where the zipper stitching was removed.
- measure from the opening in the kite to the cell wall, subtract 1cm. This is how long the sock needs to be.
-sew the sock in the direction you would use it to inflate the kite (pointing towards the centre)
- sew a deflate valve into the trailing edge to replace the deflate zipper.
By Rhys Patterson
Asking $2000 for the lot open to reasonable offers
Peter Lynn kite buggy
Bomba 13 kite surfing kite
3.6 water foil
2.4 water foil
2 x harness’s
Replacement value over $4k
Open to reasonable offers, this setup was amazing and I could go out in all conditions with this variety of kites.
Don’t have time to use it any more unfortunately.
All gear is in good working order with no issues.
Just got an Aviator bar and lines but no manual. I have set up bars before, but this looks different from what I'm used to. What's going on here...?
I know the front lines attach here, but how..? Don't want to assume anything. Also how do I attach safety line...? Cant find manual on PL website for bar.